Vehicle Splice Cables

These jump starter clamps are made of copper and aluminum wire with a total cross section of 10 mm2.Gracias Thanks to the color coded grips (red and black) and insulated clamps, the risk of an accidental.Estos short circuit is minimized. These cables Flexible starter boots are easy to store without getting tangled. They are suitable for vehicle engines of 1,600 cc or less.

These jump starter clamps are made of copper and aluminum wire with a total cross section of 35 mm2.Gracias Thanks to the color coded grips (red and black) and insulated clamps, the risk of an accidental.Estos short circuit is minimized. These cables Flexible starter boots are easy to store without getting tangled. They are suitable for all gasoline and diesel engines up to 5000 cubic centimeters.

These practical jumper cables are made of copper clad aluminum cable with a total cross section of 25 mm2. Thanks to the color-coded handles (red and black) and insulated clips, they minimize the risk of accidental short circuit. These flexible car booster cables are easy to store without tangles. They are suitable for vehicle engines of 5000 cc or less.

These practical jumper cables are made of copper clad aluminum cable with a total cross section of 50 mm2. Thanks to the color-coded handles (red and black) and insulated clips, they minimize the risk of accidental short circuit. These flexible car jumper cables are easy to store without tangles. They are suitable for all gasoline and diesel engines up to 5000 cc.

These jump starter clamps are made of copper and aluminum wire with a total cross section of 16 mm2.Gracias Thanks to the color coded grips (red and black) and insulated clamps, the risk of an accidental.Estos short circuit is minimized. These cables Flexible starter boots are easy to store without getting tangled. They are suitable for vehicle engines of 3000 cc or less.

These Carpoint vehicle jump starter cables are the perfect solution if your car won't start due to a dead battery. They are valid for use with 6, 12 and 24 volt batteries. Red and Black Color-Coded Jumper Cables: The jumper cables are color-coded (red and black) and measure 3 meters in length. They have a maximum load of up to 400 amps and metal tongs with insulated handles. Connecting jumper cables: Connect the red jumper cable to the + pole of the discharged battery. Then, connect the other red clamp to the + pole of the working battery. Finally, connect the black jumper cable to the - pole of the charged battery. Connect the ground wire for safety: Place the other black clamp over the vehicle's designated jumper point with the